Showing posts with label NEC code. Show all posts
Showing posts with label NEC code. Show all posts

Wednesday, March 18, 2015

Redmond Washington Electrical Troubleshooting

Another service call for Seatown Electric, this customer had one of there upstairs circuits that was not working. We started at the electrical panel and checked every circuit to make sure the breakers were in the on position. The customer said they checked every single breaker, But just to be safe we like to run our fingers down the Breakers and put slight tension on them to see if one is tripped in the on position. There is a lot of service calls that electrical contractor go on in the Seattle area that are similar  to this, and most of the time it is an easy fix. We look for the obvious, a bad breaker, tripped GFCI  or loose wiring first.



In this case it was a tripped breaker, stuck in the on position. A good tip for home owners to look at to save a trip fee is to turn every breaker off hard then back on. This will reset the breaker if it is in fact tripped, but in the on position. The video above can help everyday homeowners troubleshoot a simple fix.

After setting the breaker back on, power was restored. Job complete. Another satisfied Angies List customer

For questions or to schedule a free estimate please call (206)-293-0037 or visit Our Website

Tuesday, March 17, 2015

AFCI Breakers And GFCI Protection Seattle Washington

What Does an AFCI or Arc-Fault Circuit Interrupter do? Arc-Faults are designed to help prevent fires by detecting an unintended electrical arc and disconnecting the power before the arc starts a fire. Unlike GFCI devices that prevent electrical shock, AFCI breakers only detect Arc-Faults. Same goes with a standard breaker, A standard breaker only detects circuit overloads and short circuits. And the AFCI again, only detects Arc-Faults. 


Arc-Faults have created a whole new challenge for Electrical Contractors and home owners in Washington State. An example, is a typical circuit extension will now require Arc-Fault protection. If the electrical panel cannot fit the required space of an Arc-Fault protection, the homeowner might be faced with having to get a sub panel, or a full panel change out, just to bring one circuit up to code.

In dwelling units, all 15-20 Amp 120 volt circuits supplying outlets or devices are required in   kitchens, family rooms, dining rooms, living rooms, closets, hallways, laundry areas, or any other areas described in article 210.12 (A)(1) through 6. of the NEC code.

A quick rule of thumb for AFCI protection requirements, and GFCI requirements is: if you are adding or altering a circuit in a residential dwelling you are most likely going to have to GFCI protect it: bathrooms, exterior, exposed basements, garage, kitchens, wet bars, and  any wet locations. Or  AFCI protect it: Kitchens, family rooms, dining rooms, living rooms, closets, hallways, laundry areas. GFCI outlets protect from electrical shock, AFCI breakers protect from Arc-Faults. 

For a whole home safety check please visit: SeaTown Electric or call: (206)-293-0037